How to Build and Maintain your Tiny Whoop


Uncategorized / Thursday, December 7th, 2017

 

Hello everyone welcome back.

In todays video I will be showing you how to build a MultiGP ready 65mm Tiny Whoop. All the parts for this build were sent to me by BetaFPV. A huge thank you to BetaFPV. In this build you will learn how to assemble a tiny whoop. We will solder the camera and attach the video in and out for BetaFlight OSD. We will mount the flight controller stack, canopy, motors and props. This was a simple build and I have been receiving great results. This tiny whoop meets the MultiGP requirements.

I also wanted to include a short list of checks to help keep you all in the air. I hope this video helps and if you have any questions feel free to leave me a comment.

This build is of the FRSky flavor so I will be flying it with my Taranis Q X7.

If you would like to build this yourself here are all the parts I used.

 

BetaFPV Beta 65 Frame Kit
http://amzn.to/2iFx68l
BetaFPV Flight Controller with Frsky Receiver & BetaFlight OSD
http://amzn.to/2B0QeZ6
BetaFPV Flight Controller with DSMX Receiver & BetaFlight OSD
http://amzn.to/2j1f6cm
BetaFPV Z01 Camera
http://amzn.to/2j4aKBh
BetaFPV 230mah LiHV Batteries
http://amzn.to/2kwVVqY
BetaFPV Replacement Canopies
http://amzn.to/2BewWzT
 

The transmitters I use

Soldering Iron I use
http://amzn.to/2iAHoGq
FrSky Taranis Q X7
http://amzn.to/2kB2yJ6
 

Walkera Devo 7e
http://amzn.to/2B1acTo
FPV Goggles I use
Makerfire VR008 Pro
http://amzn.to/2BdkTD8
 

I film all my videos with a Samsung Note 5
http://amzn.to/2AXnKiX
 

Check out the Beta 65s
http://amzn.to/2AYHtP1
Check out the Beta 75
http://amzn.to/2BM65qW

Leave a Reply