AwesomeFPV Bobi 115 on 3s

Uncategorized / Wednesday, May 9th, 2018

Hello everyone welcome back.

In todays video I wanted to show you and review the AwesomeFPV Bobi 115mm Brushless quadcopter on 3s.

This little 2.5″ micro brushless quadcopter is a ton of fun to fly. It has a great tune out of the box and all you need to do is install your favorite receiver and you are good to go. I would like to see a better camera on future models as both the camera quality and VTX range was below my expectations.

Huge thank you to for sending this over. This post contains affiliate links. Affiliate links help me earn a commission that supports my channel and are of no cost to you.

You can pick up the bobi 115 at

Wheelbase: 115mm
Body size: 100 x 100 x 38mm ( not including propellers )
Frame material: 3K carbon fiber
Brushless motor: 1105 7000KV
Brushless ESC: 4-in-1 BLHeli – S 10A
Flight controller: OMNIBUS F3 with OSD, 5.8G VTX
Video transmitter: 5.8G 48CH 25mW
Image transmission range: about 250m
FPV camera: 600TVL CMOS
Propeller: 2535 2.5 inch
Battery: 500mAh 7.4V 2S 25C LiPo

OMNIBUS F3 Flight Controller
IMU: MPU6000
BEC output: 5V 1A
OSD: BetaFlight OSD

4-in-1 Brushless ESC
Processor: EFM8BB2
Driver: 3-in-1 MOSFET
Firmware: BLHeli – S
Continuous current: 4 x 10A

The color ( red, black and white ) of the propellers will be sent randomly.

Also be sure to check out the hobbymate lipo bag deal going on on amazon.

Thank you very much for watching.

Remember to Like, Share & Subscribe. You can click the bell for notifications.

If you like my channel and would like to donate to help support future videos you can visit the following links.

Thank you very much.

Fly Safe & Fly Often

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.